About the Authors


  • About the Author

February 2017

Sun Mon Tue Wed Thu Fri Sat
      1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28        

« Autodesk Product Imagery - It could be your design on the Inventor box | Main | Autodesk Showcase Triggers - Turning on the action in your product visualization »

08/22/2011

Comments

Feed You can follow this conversation by subscribing to the comment feed for this post.

scott

so does it only support Air, or can you adjust density to analyse a boat hull moving through the water?

Autodesk Manufacturing Toolbox

As it stand today, yes, Project Falcon only support airflow.

Steve

Do you know when it will be available for purchase? Also, do models have to be stitched first?

Autodesk Manufacturing Toolbox

It is free on Autodesk Labs now (labs.autodesk.com). not sure if/when it will be available as a purchased product.

Models do not have to be stitched.

Ed

It would be very cool and useful if there was a way to evaluate stresses on the object caused by wind...

Paul

Very cool, funny write up. Nice Higgins drop.

Thad Fransman

COULD IT BE USED TO SIMULATE AIR FLOW, VELOCITY, CFM THROUGH A DUCT RUN, SAY FROM A BLOWER AND THROUGH A VENTURI. ETC. JUDGING LOSS IN INCHES OF WATER AND SO ON? OR DO YOU KNOW OF OTHER PLUG-NS THAT CAN?

The comments to this entry are closed.